Auto Blogs | Car Forums

I to have the same problem on my 1993. I to think its the fuel pump. I cleaned all injectors, replaced all glow plugs and all filters,but still cuts out and stalls. I even removed both fuel tanks and couldn't find any thing. I to think its a FORD think...LOL

i have a 97 ford 4.6 triton i am losing compression on 5 th cylinder only and i do not have any leakage in my water or oil what would i need to do to fix it service engine light comes on and blinks sometimes when driving code saids losing 5 th cylinder  please help do you think its my block  no money for repairs my husband going ...

My 88 F150 w4.9 starts fine when cold. I tested the starter and Battery and replaced the batt. cables and a ne soleniod. after you drive it and get it hot it wont crank over like it has a dead battery. Im thinking the Battery but don't want to spend anymore money.  Thank you Travis  Florida

I am wanting to put dual tanks on my 73 F250 and on a 73 F250 4X4.  I recently acquired 2 of the heater control mounted dual tank switches.  Where can I get the valve switching assembly and do I need booster pumps in my tanks.  What else should I be looking out for and what else might I need to install the tanks on these two trucks?

Truck loses fuel pressure when hot sometimes I have replaced ECM, fuel pressure regulator,cold air temp sensor, gas caps. I have checked fuel pumps they are pumping one pint of fuel in 20seconds this does not hapen all the time but afraid to drive it some times w2hen cold inirita switch seems to be ok could it be bad? also where is the computer on ...

Want to pull the rear end gears out so that I can slide the axles out to change my front and rear pinion bearings.  How do I separate the differential from the left and right axle?  There is a Z looking pressure lock keeping me from getting my C clips out so I can slide the axles out.  Any help would really be appreciated.  ...

I have a 1996 F150 and it will not pass emissions.  The hand held tester shows a yellow light and codes C, 2A, O, OH and E. Catalyst monitor, secondary air system monitor, oxygen sensor monitor, oxygen sensor heater monitor and EGR system monitor.  I have completed the online Ford Motor Company driving cycle and the flashing codes ...

when its gets cold,my 1998 ford truck will not start,when its warm its ok.

i have a 1999 ford f150 ,,replaced starter , starter relay switch,cylanoid,, battery and cables,,at first the starter would stay ingaged  ,, then only click  ,now nothing,,,i can start it by jumping the cylanoid,,but starter still stays ingaged  ,can anyone give me some pointers ,,thanks   len

I need to replace rear wheel bearing. but the drive wheel shaft is stuck any succestions is a 2000 f-150